Name: CW SS1108-BZ-ZX Hybird Servo Driver
Brand: Jinan Hongyang CNC Machinery Co., Ltd.

CW SS1108-BZ-ZX Hybird Servo Driver

product name:	Cw SS1108-BZ-ZX hybird servo driver
Voltage :	AC70V-130V
Package dimensions: Weight:
Product introduction:	1. Built-in fan cooling 2. The running speed and running torque are greater 3. Faster response 4. Significantly reduce temperature rise and improve operating efficiency 5. Ultra-low vibration noise 6. High smoothness performance, ultra-low noise 7. Impulse response frequency up to 200KHz 8. Commonly used 90V or 110V AC transformer power supply
Instructions for use:	The CNC driver drives the stepper motor. The driver needs to select the power supply according to its supported voltage range. Then the driver is connected with the stepper motor and the control system, and the control system controls the cnc router machine running .

Driver model

Motor model

Torque

Encoder meters

Step angle

Shaft diameter

SS1108BZ-ZX

86BHH97-500B-40MP

86BHH114-450P-40MP

86BHH114-450P-40BZ

86BHH150-600P-40BZ

86BHH150-600P-40MP

4.5N

12N

1.8°

14with slot

Phenomenon	possible reason	solution
The motor does not rotate	The drive is not properly powered	Check whether the power supply whether normal
	The driver cannot receive the control signal	Check the control signal line
	Drive is not enabled	Enable signal is high or not connected
Alarm codeErr_00	Power supply voltage is too high	Check supply voltage
Alarm codeErr_01	Power supply voltage is too low	Check supply voltage
Alarm codeErr_02	Overcurrent protection	Damaged motor or driver or short circuit of motor cable, check motor and driver
Alarm codeErr_03	Motor lose step	The motor wire is connected incorrectly. The encoder wire is connected incorrectly. Check the wire and restart
	The acceleration time is too short, the motor is out of step	Increase acceleration time
	The power supply voltage is too low and the power is not enough	Increase supply voltage
Motor steering error	Wrong direction setting	Change orientation settings
Inaccurate location	Segmentation error	Set correct segmentation
Inaccurate location	Control signal is disturbed	Eliminate interference